? Key Specs
| Specification | Details |
|---|---|
| Product | Kolpin 3‑Point Hitch Complete Wire Harness (for DirtWorks 3‑Point Hitch System, model WHS03HD) |
| Weight | ~2 pounds |
| Dimensions | ~10 × 7 × 1.5 inches |
? Installation / Wiring Instructions
This wire harness is a direct replacement for the Kolpin 3‑Point Hitch System and connects as follows:
-
Brown wire connects to the negative (-) battery terminal.
-
A 6" red pigtail wire attaches to the “BAT” side of the breaker.
-
The small red wire from the main harness connects to the “AUX” side of the breaker.
-
The large red wire ring terminal connects to the positive (+) battery terminal.
-
Two white connectors—one from the main harness, one from the rocker switch—must be connected.
-
Mount the rocker switch to the left handlebar using included rubber spacers.
-
Route and secure the wire harness along the frame with zip ties. Avoid engine, exhaust, or sharp edges.
-
At the actuator unit, connect the male/female connector from the harness to the actuator input.
⚠️ Additional Notes
-
Designed for 12-volt systems with a built-in circuit breaker for protection.
-
Replaces damaged or missing original harness.
-
Ensures full electrical control of the 3-point hitch system.
-
Important to route the harness carefully to prevent damage from vibration, heat, or abrasion.
